Skip to main content

pidgin 2.3.1 支持QQ了

最近看到Pidgin升级到2.3.1了,Changelog里赫然写着改进了对QQ的支持, 于是我下载编译试了一下。(注意首先要卸了原来的)

开始时我的QQ号需要激活,还需要输入验证码,这些都是用Wine的QQ发现的。 前者上个网页就行了,后者则需要更改密码。 都还不算麻烦。

之后用pidgin连了一下,果然连上了。 只是现在不支持好友分组, 也不支持表情。

但是已经很高兴了。

Comments

Popular posts from this blog

Determine Perspective Lines With Off-page Vanishing Point

In perspective drawing, a vanishing point represents a group of parallel lines, in other words, a direction. For any point on the paper, if we want a line towards the same direction (in the 3d space), we simply draw a line through it and the vanishing point. But sometimes the vanishing point is too far away, such that it is outside the paper/canvas. In this example, we have a point P and two perspective lines L1 and L2. The vanishing point VP is naturally the intersection of L1 and L2. The task is to draw a line through P and VP, without having VP on the paper. I am aware of a few traditional solutions: 1. Use extra pieces of paper such that we can extend L1 and L2 until we see VP. 2. Draw everything in a smaller scale, such that we can see both P and VP on the paper. Draw the line and scale everything back. 3. Draw a perspective grid using the Brewer Method. #1 and #2 might be quite practical. #3 may not guarantee a solution, unless we can measure distances/p...

Installing Linux on Surface Pro 1g

Windows 10 will soon reach its end of life, and my 1-gen Surface Pro is not supported by Windows 11. I (finally) decided to install Linux to it. Fortunately, it's a not-so-easy nice adventure: The device has only one USB port, so I have to bring back my 10+-year old USB hub. My live USB drive cannot boot directly, I have to disable Secure Boot first, by holding Volume Up during boot. I think years ago I learned that booting on USB might not work through a USB hub, but fortunatelly it worked well with my setup. This is done by holding Volume Down during boot. Wifi adapter was detected in the live Linux environment, but not functional. And I don't have a USB-Ethernet adapter. Luckily, nowadays we have USB-tethering from Android phones, which works out-of-the-box. Originally I planned to following this guide to set up root on ZFS, however, the system froze when building the ZFS kernel module. Then I decided to just use EXT4, yet I still learned a lot from the guide about disk par...

Fix Google Security Code

Google Security Code (http://g.co/sc) is one type of 2-step verification. This is particularly useful when security keys and passkeys are not available. I have been using it in my LXC containers, until today I found out that it stopped working. It just kept saying "The code is invalid". It is easy to rule out some factors: The code works on other browsers on my laptop. The code works on other devices that are directly connected to the router. So it appears that Google also checks IP addresses besides the security code. Recently I have IPv6 enabled, so most devices that are directly connected to the router have both IPv4 and IPv6 addresses. But  I only enabled IPv4 for my LXC containers. So I guess when a code is generated by device A and used by device B, Google should be able to check that device A and device B are closely located. But in my case, IPv6 address appears on device A but not on device B, which may look suspicious. To fix the problem, I just needed to disable IPv...